2″ Joint Sealant Over-Banding Peel, Stick & (8) 2″ x 50′ Rolls – 400′ Quik Joint

2″ Joint Sealant Over-Banding Peel, Stick & (8) 2″ x 50′ Rolls – 400′ Quik Joint. This self-adhering rubberized asphalt strip, when placed over cracks or joints and heated, quickly fills openings and creates a permanent bond. Quik Joint creates waterproof joints while eliminating the need for special tools. One Pail of 8 Rolls of 50′ (feet) x 2” (inches) – You will receive 400 linear feet total We also offer a money back Guarantee. Our Competitors expect you to pay for shipping ***DO NOT BE FOOLED BY IMITATION “Crack Filler – Peel, Stick and Heat” YOU GET WHAT YOU PAY FOR*** RUBBERIZED NON-TRACKING JOINT AND CRACK SEALING TAPE FOR ASPHALT OR CONCRETE Purpose: This self-adhering rubberized asphalt strip, when placed over cracks or joints and heated, quickly fills openings and creates a permanent bond. Quik Joint creates waterproof joints while eliminating the need for special tools. Cost Benefit: Now you can easily extend the life of your pavement by preventing water entry through cracks and joints. Eliminate the heating time of a tar kettle; the labor and mess when using a pour pot and the equipment necessary to haul these specialized tools. QuikJoint is a self adhering rubberized asphaltic strip that can be quickly placed over the crack or joint, requiring far less time and labor. Instructions: Pavement must be clean, dry, and free of dust prior to application of QuikJoint over-banding compound. Desired pavement temperature should be 40º F (4.4ºC) and rising. Heat may be applied directly to pavement to dry and warm surface area to increase adhesion. For best results fill cracks wider than 1/16 inch with an approved crack filler level with pavement surface. 1. Peel and Separate approximately one foot of the white release paper from the over-banding joint compound. 2. Position and Press the exposed compound (underside) at the front of the joint to be sealed and adhere to the pavement by applying pressure. Continue to separate the white release liner while rolling, positioning, and pressing the compound over the entire joint to be sealed. Once the entire work area has been covered; cut the material with a straight edge and return roll to its original package. (It is not necessary to remove the clear plastic film on the topside of the material). 3. Apply heat directly to the product (the clear plastic film will burn off) using a propane torch (suggested 2” diameter torch head or larger). Constantly and repeatedly move flame over the compound material until liquefaction occurs (this will happen almost immediately). The material must be heated so that all the clear plastic has been melted and the compound is liquefied (melted) and bonded to the surface. Do not apply excessive heat causing the materials to burn or run off. The material will set up quickly and the joint is permanently sealed. Within minutes the area may be top coated with sand or sealer or opened for traffic. Properly dispose of any waste materials. I have been in the Seal-Coating Industry for 40 Years and am the Direct Manufacturer Hence Our Price Please rest assured buying from a 24 year eBay Veteran with 100% Feedback. Please Email regarding Custom Orders – Sizes/Quantities for a quote. –SHIPS SAME DAY BY 12PM EST–